As an important part of Chinese machinery manufacturing industry, the jaw crusher industry supports the mainstream equipment for the national economy and also reflects the development level of national industrialization level. With the development of economic globalization, our mining machinery industry especially the jaw crusher is moving on the intelligent, digitization and large-scale industry. At present, the crushers are widely used in phosphate. The jaw crusher is pressed down upon the fixed jaw plate by the movable jaw plate periodically and it will clamp some of materials to be crushed. The two jaw plates are rectangular. The current jaw crusher can be divided into the easy swing and complex swing according to the forms of the jaw plate swinging.
Recently, most jaw crushers are universally used in phosphate. Therefore, here we mainly introduce the jaw crusher. The jaw crusher is generally used for coarse crushing operations. It can also be used for medium crushing for the relatively small ore particle size in the small and medium phosphorus processing plant. Deandre Ayton has plenty of information regarding this issue. The most commonly crusher used in the phosphorus processing plant is the jaw crusher with form of simple swing and elbows plate. At present, the development of the mining machinery industry in China also has problems and has been restricted by low comprehensive strength, weak scientific and technological base, low product quality and other factors. Therefore, innovation and developing high-end products, has been the best way to adapt to the current economic development method, and also the future development focus for China mining machinery industry.
The Preparation Work before Jaw Crusher Being Used (1) Check the lubrication of bearing carefully and pay attention to whether the joint of thrust board that has enough lubricating grease. (2) Check carefully whether all the fasteners that are firm. (3) Check the protective device is good or not. If there is insecurity, it should be excluded in time. (4) Check whether there is some ore or other debris in the crushing cavity. If there is some ore or other debris in the crushing cavity, it must be cleaned up. The maintenance and use of jaw crusher (1) The feeding can be done after the normal operation of jaw crusher. (2) The crushing material should be put into the crushing cavity uniformly. Feeding from one side must be avoided, because the sudden load change and unilateral sudden increase will do harm to the equipment. (3) Under the situation of normal operation, the rising temperature of bearing should not exceed 35? and the maximum temperature should not exceed 70?. Otherwise, it is necessary to stop the equipment at eleven to find the reason and solve it. (4) Before stopping the equipment, the feeding must be stopped at first. And the motor cannot be turned off until all the crushing material is discharged from the crushing cavity completely. Abide by the principle of big enterprise, family and school in our culture building, Hongxing wins many honors by the exquisite techniques and advanced technology. We will always serve customers by the service tenet that to be responsible for every procedure; to responsible for every machine and to responsible for every customer. We will do our best to get your satisfaction. We firmly believe that we can get sincere repay with our sincere dedication. Cone crusher manufacturer: Raymond mill: